2 years ago

Fig xA Entropy change as a function of temperature

The TMs of the sample (as shown in Fig. 3) fell as the PQA temperature increased. A main factor that affects TMs is the change in valence read more...

2 years ago

Laboratory methods Analysis of all regulatory organic and

Fluorescence was measured in a 10 mm pathlength quartz cuvette (Starna Scientific Ltd), on both the prototype portable instrument and a bench top instrument. Emission scans were taken on the bench top device at the same peak T (280 nm) a read more...

2 years ago

The increased proportion of pesticide vulnerable taxa downstream of the

The increased proportion of pesticide-vulnerable taxa downstream of the forested reaches was mainly observed several months after contamination and was explained by enhanced recolonization processes (Liess and von der Ohe, 2005). Most previous stu read more...

2 years ago

Recoveries and method detection limit of the target analytes in

Recoveries and method detection limit of the target analytes in the investigate matrices.CompoundRiver water (n = 3)River SPM and NSC74859 (n  read more...

2 years ago

Fig shows the coating cross

Table 2.
Spray parameters of ZSTK474 bond coat and the YSZ.ParameterBond coatYSZSet 1Set 2Power (kW)12.52130Current (A)250300500 read more...

2 years ago

The formation process of the AgBr Ag porous microspheres was

Since, the generated AgBr copied the CuBr template, the diameter of these AgBr/Ag composite microspheres remains unchanged. (c) During the ion-exchange process, lots of Cu+ ions were released from CuBr template and would reduce the Ag+ ions nearby read more...

2 years ago

SU11274 Fig xA SEM micrographs of polished surfaces of

Fig. 2. SEM micrographs SU11274 polished surfaces of (a) B4C, (b) SiC–AlN–C and (c) SiC–5 wt.% B4C ceramics.Figure optionsDownload read more...