I met a proprietor at one of his properties recently that had an essential water problem with his dryer vent line. After meeting the dog owner, he required to his basement and opened up a closet. There were an accommodating dryer hose hanging at the front of my face in the big U formation. The Owner said, "I think there's water in here." Obviously, this is the reason his Tenants were having trouble drying their clothes.
I grabbed the hose, jostled it backwards and forwards, as well as the sound of water made a whooshing sound, it felt like there is two gallons water inside vent line. The load for these so much water caused the duct line to sag to a couple feet higher than the floor. Fortunately, the hose didn't yet break and cause water damage and mold across his floor.
I said to the Homeowner, "The builder have to have been very lazy because he should not of installed this kind of flexible dryer vent line inside the walls. He must have installed the rigid metal sort of dryer duct." Unfortunately, builders sometimes install the flexible foil kind of duct line in walls, and possess been even seen to sometimes exit the dryer duct into attics that's very hazardous.
Any time a flexible vent is installed rather than the rigid metal type, if you have a bit water condensation from drying clothes, this water can take shape up you need to to sag the vent line. So when the duct line sags, it just collects a lot more water. Unfortunately, the river will ultimately totally clog the vent line in the event it sags, and totally block the flow of air. When there is an airflow blockage resulting from water buildup, it could seriously damage a dryer making a powerful new dryer worthless.
Sometimes, the lake can also come from the exterior if the outside cover isn't sealed properly and rainwater pours in the dryer duct. The straightforward solution with this is always to seal the outside vent cover with clear caulk in order to use a new cover. The outer vent cover this homeowner was beneath a overhang where rain wouldn't reach it, therefore, the water was definitely via his clothes. Usually, water condensation within the duct line 's no problem, but as he'd a flexible type of hose inside wall, the slightest level of water caused it to sag and trap more and more water.
I grabbed a large plastic bucket, placed it within the sagging vent line, obtained a pen, and popped it with a hole. It almost felt as being a surgical procedure. The river gushed out of the duct line and to the bucket as well as a blend of lint. In the end water drained, I just taped the hose with vent tape.
After fixing the stream problem, I worked out my normal cleaning procedure and brushed out of the vent line from the inside, placed my blower inside vent line, and proceeded to brush it externally. More line blew out, as well as the airflow finally resumed inside vent line and it was blowing out strong.
To learn more about apartment dryer vent cleaning in baton rouge web site: this site.