clouds4bee

Welcome to my blog

longtrey0

Is another choice switches/power-over-ethernet-switches/rocketlinx-es7206">Lowest price getting your Arduino

(or another PIC)

plugged into your

circle (ethernet) - work with an vintage NSLU2!

The NSLU2 and Arduino both talk TTL, but the NSLU2 is 3.3v and Arduino is 5v. Rather simple deal with - incorperate a resistor!

Only 3 wires are required - pins 4, 2 and 3 on the NSLU2. You may not would you like to be connected

the capability pin.

For every the kitchen table here, check out the light stripe - that is the drive pin.

NSLU2 - pin-away from the J2 serial port

Pin 1 - 3.3v, pin 1 has got a bright white stripe next to it

Pin 2 - RXD, pick up from Arduino

to NSLU2 (need to have resistor)

Pin 3 - TXD, send out from NSLU2 to Arduino

Pin 4 - GND, terrain bond

This article is developed in useful resource with regard to the "Freeduino" - a BBB (bare bone table) category. Be certain that things are operated from and unplugged. Then, link the TTL pins labeled "RX", "TX" and "GND" over the Better business bureau towards the sufficient pins

with the NSLU2. The 4 serial harbour TTL pins concerning the NSLU2 are evident just beneath the battery to

the right.

You should arrange a 10k resistor amongst the

Arduino together with

the NSLU2 on pin 2 with the NSLU2 and so the

5v from the Arduino are dropped to free from danger tiers.

Now electrical power inside the NSLU2 and Arduino which happens to be flased with Debian (SlugOS might jobs also). Use minicom (apt-get) and begin up minicom and set the serial port to9600 and

ttyS0, 8N1.

The TTL pins/port on the Arduino and NSLU2 are functional you should now see the output from the Arduino

if the connections are correct. Be sure you have pre-programmed your Arduino with a program that outputs text

at the proper baud rate if you do not see anything. Also strive driving away the two of them machines, provide power to validate and attempt more. It is possible the

serial port will not work if you have made other hardware mods such as overclocking on the NSLU2.

You should point a 10k resistor regarding the

Arduino plus NSLU2 on pin 2 within the NSLU2 to ensure the

5v from the Arduino are lowered to secure and safe concentrations.

Now force up the Arduino and NSLU2 that has been flased with Debian (SlugOS should effort also). Add minicom (appropriate-get) and begin up minicom and set the serial harbour tottyS0 and 9600, 8N1.

If the connections are correct, the TTL pins/port on the Arduino and NSLU2 are functional you should now see the output

from the Arduino. If you do not see anything, be sure you have pre-programmed your Arduino with a program

that outputs text at the proper baud rate. Also you could try running from at the same time models, effectiveness validate and check out once again. If you have made

other hardware mods such as overclocking on the NSLU2, it is possible the serial port will not work.