Gas Oil Separation Plant Pdf Free
Gas Oil Separation Plant Pdf Free > http://shorl.com/pofrytratremobi
It is often appropriate to separate gases and liquids for separate use. hydrogen sulfide and sulfuric acid) and is then called "sour". External links. Contents 1 Reasons for processing 1.1 Pressure 1.2 Contaminants 1.3 Phase separation 1.4 Gas recovery 2 References 3 External links . The raw crude often leaves the well head under very high pressure. Production pressures of greater than 23,000 pounds per square inch (1,600atm) is not uncommon. .. The sulfur can be very difficult to remove since it may be bound to molecules in the crude and encapsulated in this. on offshore platforms). This process is then reversed at storage by adding demulsifiers that makes the water fall out, and can be tapped from the bottom of the tank. The package is fitted the well head after the choke valve and before the production manifold, and separates the crude oil from sediments, solids and sand (below using a filter) and gases and condensates to allow the crude to be pumped on the pipeline. Gas recovery. Reasons for processing. The gas and condensate are pumped on designated pipelines for this, while the sand and sediments require special handling. Contaminants. Modern oil recovery may place a hydro-cyclone to replace the GOSP, allowing the water to be removed immediately and re-injected into the well. After storage of the crude this can be sold to refineries, that then produce the fuels, chemicals and energy we consume. Crude that contains water is called "wet", and the water can then be bound in an emulsion in the crude to allow pumping on a pipeline.  . A gas/oil and water separator is called a 3-stage separator. Phase separation.